Aftermarket GRACO® 25M244 Teflon O-Rings 248-137 (50-pack) (Non-OEM)
Manufacturer: Total Finishing Supplies
Part Number: 75732
Comparable OEM Part Number: 25M244
Description: Total Finishing’s part # 55-3206 is a 50-pack of PTFE (Teflon) o-rings supplied as a direct-fit replacement for GRACO® 25M244. PTFE o-rings deliver broad chemical resistance, low compression set under repeated pressure cycles, and a stable seal at fluid passages in high-pressure spray equipment.
GRACO® airless and plural-component equipment runs these seals at pressures where any loss of seal integrity shows up immediately as a leak or pressure drop.
Common reasons these o-rings are replaced:
- Fluid leaking at fittings, swivels, or gun manifolds during spraying
- Pressure loss caused by a swollen, extruded, or compressed o-ring
- Visible compression set, flat spots, or surface cracking after solvent exposure
- Scheduled service during gun rebuild or fluid section overhaul
Manufactured to OEM-equivalent dimensions for proper fit and performance.
Comparable to GRACO® 25M-244
NOTES:
GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip are registered trademarks of GRACO®, and the same company may claim unregistered trademark rights in other words. The advertised parts are intended to fit GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip spray equipment. They are not, however, manufactured, endorsed, or sponsored by GRACO® or any of their affiliates, and no warranty by GRACO®, or any of their affiliates applies. Total Finishing Solutions, LLC is not affiliated with or sponsored or endorsed by GRACO® and is not one of their authorized distributors.
Reviews
There are no reviews yet.