Aftermarket GRACO® 206399 Intake Valve with 3/4″ NPT(m) Inlet Thread (Non-OEM)
Manufacturer: Total Finishing Supplies
Part Number: 619197
Comparable OEM Part Number: 206399
Description: Total Finishing’s part # 58-1582 intake valve is a direct-fit replacement for GRACO® part 206399, used in 23:1 Monark, EH 333. It installs in the original position with no modification.
Common reasons this intake valve is replaced:
- A worn or pitted seat face
- The ball no longer seating and holding pressure
- Loss of prime, or pressure that will not hold at shutdown
- Normal wear from abrasive or high-solids coatings
Manufactured to OEM-equivalent dimensions for proper fit and performance. Compatible equipment models are listed in the Compatible Equipment section below, where available.
Comparable to GRACO® 206-399
NOTES:
GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip are registered trademarks of GRACO®, and the same company may claim unregistered trademark rights in other words. The advertised parts are intended to fit GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip spray equipment. They are not, however, manufactured, endorsed, or sponsored by GRACO® or any of their affiliates, and no warranty by GRACO®, or any of their affiliates applies. Total Finishing Solutions, LLC is not affiliated with or sponsored or endorsed by GRACO® and is not one of their authorized distributors.
ALL FITTINGS, VALVES, & ADAPTERS ARE NOT RETURNABLE. ALL SALES ARE FINAL
Reviews
There are no reviews yet.