Aftermarket GRACO® 108982 Connector, push-on, drain tube (Non-OEM)
Manufacturer: Total Finishing Supplies
Part Number: 326946
Comparable OEM Part Number: 108982
Description: Total Finishing’s part # 12-1976 is a direct-fit replacement for the GRACO® 108982 connector, push-on. It is a connector used to join fluid or air lines in spray equipment plumbing, providing a sealed joint under working pressure.
Common reasons this connector, push-on is replaced:
- Sealing surface wear causing fluid leakage at the joint
- Thread or barb damage from improper installation
- Cracking at the connector body under working pressure
- Routine replacement during scheduled fluid line service
Service technicians install this part during routine maintenance and during diagnostic teardowns of GRACO® spray equipment when the listed failure modes appear.
Manufactured to OEM-equivalent dimensions for proper fit and performance.
Comparable to GRACO® 108-982
NOTES:
GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip are registered trademarks of GRACO®, and the same company may claim unregistered trademark rights in other words. The advertised parts are intended to fit GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip spray equipment. They are not, however, manufactured, endorsed, or sponsored by GRACO® or any of their affiliates, and no warranty by GRACO®, or any of their affiliates applies. Total Finishing Solutions, LLC is not affiliated with or sponsored or endorsed by GRACO® and is not one of their authorized distributors.
ALL FITTINGS, VALVES, & ADAPTERS ARE NOT RETURNABLE. ALL SALES ARE FINAL
Reviews
There are no reviews yet.