Aftermarket GRACO® 164654 Retainer, piston valve washer (Non-OEM)
Manufacturer: Total Finishing Supplies
Part Number: 493962
Comparable OEM Part Number: 164654
Description: Total Finishing’s part # 12-1479 is a direct-fit replacement for the GRACO® 164654 retainer. It is a retainer used inside a Bedford-compatible OEM assembly to hold a seal, seat, or component in position under working pressure.
Common reasons this retainer is replaced:
- Wear at the retainer contact face causing component play
- Damage during disassembly of the assembly being serviced
- Sealing failure allowing fluid bypass or contamination
- Routine replacement during scheduled pump or valve rebuild
Service technicians install this part during routine maintenance and during diagnostic teardowns of GRACO® spray equipment when the listed failure modes appear.
Manufactured to OEM-equivalent dimensions for proper fit and performance.
Comparable to GRACO® 164-654
NOTES:
GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip are registered trademarks of GRACO®, and the same company may claim unregistered trademark rights in other words. The advertised parts are intended to fit GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip spray equipment. They are not, however, manufactured, endorsed, or sponsored by GRACO® or any of their affiliates, and no warranty by GRACO®, or any of their affiliates applies. Total Finishing Solutions, LLC is not affiliated with or sponsored or endorsed by GRACO® and is not one of their authorized distributors.
Reviews
There are no reviews yet.