Aftermarket GRACO® 101822 Piston Ball, Stainless Steel (Non-OEM)
Manufacturer: Total Finishing Supplies
Part Number: 305466
Comparable OEM Part Number: 101822
Description: Total Finishing’s part # 9-995 is a compatible replacement for GRACO® parts 101822 and 101-822 — the ball used in GRACO® spray equipment. This ball is the moving element of a check valve in the pump’s fluid section: on each stroke it lifts off its seat to let coating through, then reseats to hold pressure. Compatible with GRACO® 15:1 President, 25:1 Senator Dura-Flo 600, 41:1 Bulldog Dura-Flo 600, Dura-Flo 600, HydraMax 300, HydraMax 350 and other GRACO® equipment.
Common reasons for replacement:
- Replaced together with its seat during a fluid-section rebuild
- Sprayer loses prime or pressure as the ball wears out-of-round
- Fluid backflow from a ball that no longer seats cleanly
- Pitting or scoring from abrasive coatings
Manufactured to OEM-equivalent dimensions for proper fit and performance.
Comparable to GRACO® 101-822
NOTES:
GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip are registered trademarks of GRACO®, and the same company may claim unregistered trademark rights in other words. The advertised parts are intended to fit GRACO®, PerfomAA™, Merkur™ and Reverse-A-Clean® (RAC) Tip spray equipment. They are not, however, manufactured, endorsed, or sponsored by GRACO® or any of their affiliates, and no warranty by GRACO®, or any of their affiliates applies. Total Finishing Solutions, LLC is not affiliated with or sponsored or endorsed by GRACO® and is not one of their authorized distributors.
Reviews
There are no reviews yet.